Home > Support > Knowledge Base

Knowledge Base

All
Configuration: 5 result(s) found
Installation: 4 result(s) found
Hardware: 7 result(s) found
Miscellaneous: 4 result(s) found
Troubleshooting: 2 result(s) found

 

There are 9 search results for ""
Maximizing range
Category: Installation, Hardware
This document introduces the basics of a wireless communications system and explains how to maximize range when commissioning a system. It explains how to install radios, antennas and cables in a way to maximize the reliability of communication. ...
Intrinsic safety certifications
Category: Hardware, Miscellaneous
What information do I need to obtain Intrinsic safety certifications? Digi radio modems have been integrated by a number customers into products that are used in hazardous environments. For electronic equipment to be used in environments with com...
Antenna Connection Options
Category: Hardware, Installation
In order to comply with FCC rules and obtain a "modular" certification, it is required that Digi radios utilize a "non-standard" connector. This is to ensure that the radios are used only with approved antennas. Below are the various antenna options ...
XBee ZigBee Route Discovery and Network Address Discovery
Category: Configuration
In ZigBee there are two important forms of discovery that allow one node to locate and send packets to another node. These two methods are called Route Discovery and Network Address Discovery. Route Discovery: In order for an XBee module to sen...
RoHS Certificate of Compliance
Category: Miscellaneous
RF Products as of 1 June, 2013 The wireless devices identified in this certificate are in compliance with the European Union Directive 2011/65/EU on the restricted use of certain hazardous substances (RoHS Directive / RoHS II Directive). Based o...
Recovery procedure for Digi RF products
Category: Configuration, Hardware, Troubleshooting
This article is an all-inclusive guide for recovering a Digi RF product that is in an unresponsive state. Please click on the type of radio you are experiencing problems with to go to the appropriate section: • General troubleshooting...
XBee-PRO 900HP Available Frequencies
Category: Configuration, Hardware, Installation
USA/Canada Part numbers ending in 001/002 AF = 0xFFFFFFFFFFFFFFFF Channels: 0 - 63 Frequency: 902.4 - 927.6 MHz Bit (Channel)   0 – 902.400 Bit (Channel) 32 – 915.200 ...
Optimizing USB to Serial Port Settings 
Category: Configuration, Hardware, Installation, Miscellaneous, Troubleshooting
Digi interface boards and USB adapters use an FTDI Chip for the USB to serial conversion. The default configuration for FTDI's drivers are optimized for high speed serial devices. Digi RF radios operate at lower baud rates than are optimal for these ...
Digital and Analog Sampling Using XBee Radios
Category: Configuration, Hardware, Miscellaneous
  XBee radios have multiple I/O lines that can be used to gather Digital or Analog data, and then transmit that data to another XBee for interpretation. Because sample data is always provided in an API format, it can be very intimidating and...
Contact a Digi expert and get started today! CONTACT US

Desktop Site