Home > Support > Knowledge Base > Knowledge Base Article

How To Install the RealPort Source RPM Driver in SuSE Linux

Installation process for installing RealPort in RedHat

Be sure there are no existing RealPort drivers installed on the system. If so, please remove prior to installing newer versions (rpm -e dgrp).

Installation preparation in Linux:

  1. Log the installation:

    # script [ENTER]

  2. Verify your kernel source is installed and matches your running kernel by typing:

    # rpm -qa | grep kernel-source
    # uname -r

    The version numbers and extensions must match exactly.

  3. In the directory where the driver source rpm is located, issue the rpmbuild command:

    # rpmbuild --rebuild 40002086_X.src.rpm

    Note: For SuSE version 8.x use:  rpm --rebuild 40002086_X.src.rpm

    # cd /usr/src/packages/RPMS/i586

  4.          Change i586 to match your actual architecture (i.e. x86_64, amd64, etc...)

  5. Use rpm to install the new driver package by typing:

    # rpm -ivv dgrp-(version).i586.rpm [ENTER]

  6. Load the module by typing and configure your Digi PortServer units using the graphical tool from an Xterm session:

    # /usr/bin/dgrp/config/dgrp_gui

    Configuring from the command line:

    # dgrp_cfg_node init (ttyid) (ip_address) (number_of_ports)

    The following example configures a 16 port PortServer with device names of ttya00 through ttya15:

    # dgrp_cfg_node init a 16

  7. Completing the installation, press:

    # [Ctrl] d

    If any errors occur during this installation, please send the file named typescript located in the directory where you began this installation to Support Wizards for analysis.

    Upon successful installation your devices will be labeled /dev/tty[id][00-99]. The id is specified during the dgrp configuration.

    Contact a Digi expert and get started today! CONTACT US

    Desktop Site