How do I reset the Digi Connect Wan to Factory Defaults.

The unit has a small blue recessed button which is marked "RESET". Power the unit off (unplug the power supply for the unit). With something that is not sharp, like a pen or bent paperclip or similar, press and hold down the reset button and power the unit back on (reconnect the power supply for the unit). The Link and Activity lights will flash once whether or not the unit is plugged into the network. Continue to hold the reset button down until you see the Status LED (Located under the Power LED) flash in the pattern 1-5-1. This may take anywhere from 5 to 20 seconds. At this point you can release the reset button. The unit should now be set to factory defaults. You will have to run the setup wizard to configure the device.
Your M2M Expert®for Businessfor Developers
Contact Us
Phone
Email
Chat
Feedback
Newsletter SignupYouTubeGoogle+FacebookCopyright © 1996-2014 Digi International Inc. All rights reserved. Legal