3) Configure the Radio
You’ll configure the radio using your free Device Cloud account. (Note that radios can also be configured using XCTU.)
NOTE: If your radio was recently configured by the XBee Zigbee Cloud Kit then the sampling rate and pin settings are already set. You can safely skip these steps.
- Log in to Device Cloud.
- Select Devices under the Device Management tab.
- Select the XBee Zigbee that you are configuring, then select Properties or double-click to open the Properties window for that device.
- Select Configurations, then Input and Output Settings, then confirm that DIO1/AD1/SPI_ATTN is set to Analog Input.
- On the same page, confirm that Sample Rate is set to 5000 ms which will take a sample every five seconds.
- Save your changes!