Battery replacement

Before replacing the battery, review the safety information and make sure you have the necessary tools and equipment. For more information about battery life, see Battery life.

  1. Unscrew the four cover screws and open the enclosure cover.
  2. Disconnect the battery.

    1. Press in the tab at the top of the battery wire connector.

    2. Pull up on the connector.

  3. Remove the existing battery.

  4. Place the new battery in the battery holder and connect the wiring to the battery port. Make sure the battery and its wiring are properly placed.

  5. Press the Wake button and wait for the battery LED to slowly blink blue five times and then remain off.

  6. Reassemble the device.

    It is recommended that you apply lubricant to the gasket when you change the battery.

    1. Retrieve the gasket lubricant kit that was provided with the Connect Tank components.
    2. Open the lubricant pouch and use the swab to apply the lubricant onto the gasket.

    1. Place the enclosure cover onto the base. The green dots on the cover and the base must both be on the same side of the device, as show below.

    Note Make sure that the battery holder in the cover aligns with the battery holder in the base. This ensures that a gap does not appear between the cover and the base.

    1. Verify that an adequate seal is present between the cover and the base.
    2. Tighten the screws.

CAUTION! Cover screws are required as part of the safety rating. When tightening the cover screws, use a screw torque of 0.79 to 1.92 newton meters (7 to 17 inch pounds).