Device controls

The following figure shows the controls for setting up and configuring the Connect Tank device.

Item	Name	Description
1	USB type B port	Connects the device to a computer using a standard USB type A to B cable; used to access the command line interface (CLI). Note Do not use the mini USB port, which is covered by a red X in the graphic.
2	Battery holder	Compartment for the battery.
3	Battery port	Port where the battery connects to the device.
4	SIM card tray	Holds the SIM card.
5	Wake button	Wakes up the device. Skips the GPS location process during device configuration.
6	Factory button	Press and hold this button for a few seconds to remove all configuration changes and restore the device to its original state. If you accidentally press this button, but do not hold it down, the device wakes and immediately returns to sleep mode.
7	Reset button	Press this button to restart the device when it is not responding to inputs (from the CLI or otherwise), such as when one or both lights remain on for an extended period of time.