Step 3: Generate the Transmit Request frame
This topic describes how to generate a Transmit Request frame using the XCTU SENDER console.
- Go to the SENDER console and detach it to see two consoles at the same time.
- In the SENDER console, click Add new packet to the list .
- Open the Frames Generator tool.
- In the Protocol control, select Zigbee.
- In the Frame type control, select 0x10 - Transmit Request.
- In the 64-bit dest. address box, type the 64-bit address of the RECEIVER module.
- In the RF data box, click the ASCII tab and type the message "Hello, this is SENDER!"
- Click OK.
- Click Add frame.