Digi Embedded Yocto version

Note Click here to view the latest Digi Embedded Yocto documentation (2.4-r2), now available in our new Digi Embedded documentation portal.

Step 2: Set up the hardware

Follow these steps to set up your ConnectCore 6UL SBC Express hardware:

 

  1. Connect the micro-USB Y-cable to the CONSOLE/POWER micro USB port and to your host computer. The operating system will detect the board as a new serial port. Identify the new serial port on your operating system (/dev/ttyUSBx in Linux, COMx in Windows), as you will need to open a console at that port in the following step.
  2. Connect the Ethernet cable (not included) to the Ethernet port.

 

© 2019 Digi International Inc. All rights reserved.
Step 2: Set up the hardware updated on 07 February 2019 12:01:30 AM