OPTIONAL: Use the CORE module to connect to the cellular network (AnywhereUSB 8 and 24 port devices ONLY)

This section explains how to connect the CORE module and cellular antennas to the AnywhereUSB Plus hardware. You can then connect to a cellular network to connect to a support management tool, such as Digi Remote Manager.

You must have purchased a CORE module to be able to connect to the cellular network.

Note This section applies to AnywhereUSB 8 and 24 port devices ONLY. You cannot configure a cellular network connection for an AnywhereUSB 2 device.

Prerequisites

• Activated SIM card(s) from your cellular network provider. Up to two SIM cards can be inserted into the CORE module.
• A CORE module may be included with your device. If it is not, you must purchase one separately.

• Make sure that your device is powered down before removing or installing the module. CORE modules are not hot-swappable.

Connect the hardware and connect to the cellular network

1. Power down the device. CORE modules are not hot-swappable.
2. Insert your activated SIM card (or cards) into the CORE module. The notched end of SIM card should be inserted first, with the gold metal contacts facing down. You will hear a click once the SIM is completely inserted.

Note If one SIM card is being used, insert the SIM card into the SIM 1 slot.

3. Insert the CORE module into the device.
   1. Orient the device so the rear of the device is facing you.
   2. Remove the CORE module slot cover from the back of the device.
   3. Insert the CORE module into the slot. Make sure the pin holes on the back of the module match the location of the pins in the slot.
   4. Push the module into the slot.
   5. Push the white handle in until you hear it click.
   6. Optionally, you can screw one of the CORE module cover screws into the center of the handle.
   7. Place the CORE module slot cover over the CORE module. Make sure that the antenna labels are oriented correctly.
   8. Use the two screws to attach the CORE module slot cover to the device.
4. Attach both of the antennas included with the CORE module equipment. While gripping the metal connector section with your thumb and forefinger, tighten until secure. Do not tighten the antenna by holding any part of the plastic antenna housing.

   Note Attaching both antennas ensures maximum performance. If a single antenna solution is required, it must be attached to the antenna port labeled MAIN.

5. Connect the appropriate power supply for your model to the device.
   • AnywhereUSB 8 Plus Hub: Connect the power supply to the Hub and tighten the screws to secure.
   • AnywhereUSB 24 Plus Hub: Connect both IEC 60320 power supplies into the Hub.

     Note Digi recommends that you purchase an additional power supply for the following reasons:
     **More power is needed if you use all 24 ports.
     **Two power cords maintain redundancy if one power supply fails. Digi also recommends plugging each power cord into separate main power circuits.
     **Helps maximize heat dissipation.
     

6. Plug the power supply to an outlet.

   Note For an AnywhereUSB 24 Plus Hub, plug both power supplies into an outlet, if you are using both power supplies. Digi recommends plugging each power cord into separate main power circuits.