Home/Support/Support Forum/Send data from DIGI WI-ME to remote server
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Send data from DIGI WI-ME to remote server

0 votes
Hi,
I am using DIGI WIME -S module with plug and play firmware. I have try alots of method to send data to remote server from DIGI WIME. Unfortunately , it failed.
The DIGI WIME is connected to network since i can access its WEB UI. Below are the commands that i send to DIGI WIME through serial.

"set wlan authentication=open\r",
"set wlan encryption=wep\r",
"set wlan channel=6\r",
"set wlan wepmode=128bit\r",
"set wlan ssid=myrouter\r",
"set wlan wepkey1=544301301D021764050087ABCD\r",
"set network gateway=192.168.1.1\r",
"set network submask=255.255.255.0\r",
"set network ip=192.168.1.109\r",
"set network dhcp=off\r",
"set network autoip=off\r",
"set network static=on\r",
"set autoconnect ipaddress=192.168.1.106\r",
"set autoconnect ipport=5001\r",
"set autoconnect connect_on_string=connecting\r",
"set autoconnect flush_string=on\r",
"set autoconnect nodelay=on\r",
"set autoconnect state=on\r",
"set tcpserial buffered=on\r",
"set tcpserial endpattern=sent\r",
"connecting COME THE TESTING DATA sent"

**************************************************
***************************************************

After sending the commands, the serial replies from DIGIWIME are as follows;

#> set wlan authentication=open
Evaluation of your saved wireless settings:

#> set wlan encryption=wep
Evaluation of your saved wireless settings:

#> set wlan channel=6
Evaluation of your saved wireless settings:

#> set wlan wepmode=128bit
Evaluation of your saved wireless settings:

#> set wlan ssid=myrouter
Evaluation of your saved wireless settings:

#> set wlan wepkey1=544301301D021764050087ABCD
Evaluation of your saved wireless settings:

#> set network gateway=192.168.1.1
#> set network submask=255.255.255.0
#> set network ip=192.168.1.109
#> set network dhcp=off
#> set network autoip=off
#> set network static=on
#> set autoconnect ipaddress=192.168.1.106
#> set autoconnect ipport=5001
#> set autoconnect trigger=string
#> set autoconnect connect_on_string=connecting
#> set autoconnect flush_string=on
#> set autoconnect nodelay=on
#> set autoconnect state=on
#> set tcpserial buffered=on
#> set tcpserial endpattern=sent
#> connecting COME THE TESTING DATA sent

The server does not receive anything and i believe is due to the DIGI-WIME does not send out the data to server.
Do I make mistakes on the configurations or other things ?
Please help.

Thanks.
asked Aug 18, 2008 in Plug N' Play by Johnny New to the Community (0 points)
recategorized Dec 18, 2013 by tuxembb

Please log in or register to answer this question.

...