Whenever my program has an exception, the error message comes out com0 instead of stdio, which I have set to com1. Is there some config that I can change so it comes out com1 like it should? It's annoying because the extra data messes up the equipment connected to com0, not to mention I can't easily see the exception data.
The changes I made for changing the stdio port:
#define BSP_STDIO_PORT "/com/1"
#define BSP_DIALOG_PORT "/com/1"
#define BSP_SERIAL_PORT_2 BSP_SERIAL_UART_DRIVER
Message was edited by: turbo2ltr