Home/Support/Support Forum/GPIO initial state
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

GPIO initial state

0 votes
Digi Connect ME devices now allow (as of firmware version F5) the initial state of the GPIO (upon power up) to be configurable so a GPIO "out" pin can be set to be de-asserted upon power up. It is straight forward to do this from the web interface though I would like to do it programmatically, ideally using RCI. Anybody know how to do this?
asked Oct 30, 2007 in Plug N' Play by junjun New to the Community (0 points)
recategorized Dec 18, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
Hmmm, interesting.

I built a SPI on the GPIO pins a few years ago, but was forced to give up because they all started high (instead of tri-state like they should) and that locked up my SPI bus. I will be watching to see what answers you get.

-Erik
answered Nov 2, 2007 by egawtry Veteran of the Digi Community (349 points)
...