Home/Support/Support Forum/difference between CLI and dialog
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

difference between CLI and dialog

0 votes
When I create a new NET+OS project with Digi ESP I can enable the CLI (via telnet or serial port) and I can configure settings for the 'dialog' (dialog port, baud rate en delay). What's the difference between these two?
asked May 31, 2007 in NET+OS by compie Community Contributor (55 points)
recategorized Dec 18, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
The dialog menu is that menu that pops up for 5 seconds right after boot up and right before you hit applicationStart on the interface specified in your appconf.h file (APP_DIALOG_PORT). The CLI is a totally different interface that allows you to telnet into the module during run time or access it over the serial port after you've hit applicationStart.
answered May 31, 2007 by charliek Veteran of the Digi Community (408 points)