Home/Support/Support Forum/problems with uploading .NET Micro Framework to Connect ME C module
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

problems with uploading .NET Micro Framework to Connect ME C module

0 votes
Hello,
I would like to ask you for help. I have tried to upload .NET Micro Framework to our JTAG Connect ME module folowing instructions in <DigiConnectME_MicroFramework_22Dec06.zip> file, downloaded from Digi web pages. I was succesful to upload <rom.bin> file and start FTP application with new bootloader. But than I was not able to download beta 3 version file <image.bin>. When I try to open FTP connection to module, it's refused.

Do you have any idea what is wrong? I send printings from terminal console, it's below.
Or if you can forward me to someone else.

thank you for help,

Michal Dvorak

************************************************************
In ncc_init()
ncc_init: Rom Image
ncc_init(): RAM is setup and tested
In blrom main()
In blrom main() signature good
In blrom main() BL_IS_COMPRESSED
In blrom main() jump toIn ncc_init()
ncc_init: Ram Image
In blram main()
In NABlMain()
isImageValid(), signature is GOOD
should not DownloadImage
BL_IS_COMPRESSED
In ncc_init()
ncc_init: Ram Image



NET+WORKS Version 6.4
Copyright (c) 2000-2004, NETsilicon, Inc.

PLATFORM: connectme
APPLICATION: Ram-based FTP Server Application
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.1.80
LAN interface's subnet mask is 255.255.255.0
IP address of default gateway to other networks is 0.0.0.0
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
This board's serial number is N99999999
This board's MAC Address is 00:40:9D:43:35:97
After board is reset, start-up code will wait 5 seconds
Default duplex setting for Ethernet connection: phy Default
Press any key in 5 seconds to change these settings.

************************************************************
asked Apr 4, 2007 in NET+OS by dvorak_mikroklima New to the Community (4 points)
recategorized Dec 18, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
Hi Michal,

Converting from -C to Micro Framework versions was only supported in the beta, but is not supported with the released platform. The .NET Micro Framework code is only licensed to run on -MF modules (not -C or -S modules).
answered Apr 24, 2007 by johnleier New to the Community (19 points)
...