Home/Support/Support Forum/Unable to changes MAC address on Digi Connect ME
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Unable to changes MAC address on Digi Connect ME

0 votes
I have tried to changes the MAC address on a Digi Connect ME module, by using the function customizeSetMACAddress(BYTE* mac_addrp) but the MAC address remains the same.

I am using Net-OS 7.1.10.0, on Digi Connect ME w/4MB Flash.

Have anyone used this function with success?
asked Jan 12, 2010 in NET+OS by larsrp New to the Community (1 point)
recategorized Dec 10, 2013 by tuxembb

Please log in or register to answer this question.

2 Answers

0 votes
Hello

In your last post you stated "but the MAC address remains the same". customizeSetMACAddress writes the updated MAC address to FLASH. Thus you would not see an update until you power cycle the device. You do not saw whether or not you power cycled the device just that you do not see the updated MAC address. So I have no way of knowing your "whole story".
answered Jan 12, 2010 by dakotas_dad Veteran of the Digi Community (694 points)
0 votes
Thanks for your reply, I have found the solution to my problem, I have power cycle the device after changing the MAC address, but somewhere in the application was the parameters in NVRam changes so the first changes of the MAC address was overwritten before the power cycle of the device.
answered Jan 13, 2010 by larsrp New to the Community (1 point)
...