Home/Support/Support Forum/I2C with ME 9210
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

I2C with ME 9210

0 votes
I have a problem, cannot customise connection I2C of port. OS windows XP, 9210-S Plug and Play Firmware unit. I am connected through TCP socket on 2101 port (by default). I send any command, but on an output there is no activity (I look an oscillograph). Can it is necessary customise GPIO, if yes that as?
asked Jul 6, 2010 in Plug N' Play by Ivan_User New to the Community (1 point)
retagged Dec 10, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
Hello,
I have similar problem, The NAI2CInit returns success but NAI2COperation always fail. No activity on the dedicated I2C lines. I spend couple of days trying to make it work (I am pretty sure my GPIO setting is correct) and finally gave up using the driver and now I am going to manipulate I2C lines using bit banging.
Actually there is no much sense of using the (quite complicated) driver to manipulate couple of bits.
answered Jul 12, 2010 by Andrey New to the Community (11 points)
...