Home/Support/Support Forum/Problem with a xon/xoff flow control in a digi acceleratot 8 port
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Problem with a xon/xoff flow control in a digi acceleratot 8 port

0 votes
Hi I have a digi board with Red Hat Linux 7.2.
The problem is that when I send a job and if the printer is not ready or is off the job is send and when the printer is ready the job is over.

Also we have seen that when the job have more than nine page at the page 10 the printed information have not sense , all is garbage , it seam to be that the xon/xoff is not working properly
asked Mar 26, 2004 in Portserver TS by ralph New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Possibly a flow control issue. We have several documents describing printer setup in a Linux environment in our Knowledge Base.

If you don't find what you're looking for there, more indepth troubleshooting might be needed so it would be a good time to call Technical Support.
answered Mar 31, 2004 by michaelt Veteran of the Digi Community (768 points)
...