Home/Support/Support Forum/Reading input buffer on TS 4 Device?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Reading input buffer on TS 4 Device?

0 votes
While I can send a message out through the TS 4 device to a remote (Tandem) host, I cannot receive anything back from the serial port. I am using a term type of dumb, a mode of RAW with autoconnect.

I can log onto the TS 4 using telnet.

Is there any way (command or otherwise) that will allow me to "see" or monitor the incoming data buffer? I am guessing that the message returned from the remote host may be coming in but there is no "trigger" to cause the TS 4 to send the data to the serial port.

Advice Please???
asked Feb 18, 2004 in Portserver TS by r.mariotti New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You can capture inbound data on a TS4 product by activating the port buffer utility:

#> set buffer range=(port#) state=on size=(0-64 [in kb])

To display buffered data:

#> display buffers range=(port#)

You may also want to consider using a network trace application to monitor the data from point-to-point. Ethereal, tcpdump and sniff are commonly used.
answered Feb 18, 2004 by userid0 Veteran of the Digi Community (2,158 points)
...