Home/Support/Support Forum/Unable to renumber ports on 8-port acceleport
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Unable to renumber ports on 8-port acceleport

0 votes
Hi, I installed an acceleport 8port on a pc and xp recognized it ok. The problem is the ports show up in device manager as com11 thru com 18. When I attempt to renumber to Com3 t, a message pops up saying port is in use. I suspect a digi board was previously installed that is acting as a phantom board and "claiming" these ports.

In device manager, I checked "show hidden devices" but don't see the phantom board.

So, I'm stuck on how to proceed next.
asked Nov 10, 2010 in Serial Cards by rtw44 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi,
I believe you are correct in your assesment. If any previously installed serial card was removed without uninstalling the drivers first, you can have these phantom ports.
To resolve, try the steps at this link:
http://www.digi.com/support/kbase/kbaseresultdetl.jsp?id=274
answered Nov 10, 2010 by Admin Veteran of the Digi Community (732 points)
...