Home/Support/Support Forum/One wire problem
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

One wire problem

0 votes
Hi, I am working with 1kb EEPROM DS2431 one wire device in connectcore W1-MX51 early availability board. I loaded the slave module first and then the master module [:(] . For reading/writing to the device, the 1-wire driver provides a binary attribute inside the sysfs. In the case of the DS2431, this attribute is placed under the following path and with the following attributes
ls /sys/devices/w1_bus_master1/bus/devices/2d-0000015db4d0/
The 2d-0000015db4d0 is the unique device id that will appear after the master detects the slave device.
In my case I connected two devices in parallel but only one device is detected in sysfs.
I googled but I didn't find any clue why the 2nd device is not detected.
Did I miss anything?

Thanks in advance for your help.
asked Apr 12, 2012 in Linux by Soya New to the Community (0 points)
recategorized Nov 26, 2013 by Yeshas

Please log in or register to answer this question.

...