Home/Support/Support Forum/How to change IP Address for Digi TFTP Server?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to change IP Address for Digi TFTP Server?

0 votes
How does one change the IP Address used by the BootLoader/Monitor for purposes of accessing the remote (Workstation) TFTP Server that runs on my Desktop PC?

Our corporate LAN does not use/allow network address: 192.168.xxx.xxx

I am assuming that the Digi TFTP server installed by JumpStart on the Desktop PC automatically utilizes the IP Address that is assigned via DHCP to the PC's Ethernet adapter ??
asked Aug 12, 2011 in Linux by gerlad0 New to the Community (4 points)
recategorized Dec 3, 2013 by tuxembb

Please log in or register to answer this question.

3 Answers

0 votes
OK. Your will get IP from your corporate DHCP server. for me my our subnet is 10.80.x.x

My PC is ->

In Uboot enviornment variables i will change serverip like below:-
In uboot prompt:-

$setenv serverip (your PC)
$setenv ipaddr (make sure this is unused by any other machine.)
$setenv gateway (this will help if your PC is not in same subnet)
$setenv dhcp off (this is important if it is ON it will NOT work.)

Then try
$update linux tftp
answered Aug 12, 2011 by bobthomas13 Seasoned Professional (182 points)
0 votes
Thanks Bob - a big help in a very timely fashion.

Appreciate the reference to U-Boot, that triggered a thought process that led me to the U-Boot Reference Manual. Fog is beginning to lift!
answered Aug 12, 2011 by gerlad0 New to the Community (4 points)
0 votes
Thanks Bob-Thomas, you "accidentally " help me too. I found your post very helpful to repair corrupted flash. I'm new to embedded Linux.
answered Apr 17, 2012 by ZiggySz New to the Community (2 points)