Home/Support/Support Forum/DC-ME-01-T-S GPIO configuration commannd
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

DC-ME-01-T-S GPIO configuration commannd

0 votes
We need to configure 4 pins of Digi-ME as GPIO lines along with the serial output. For serial we would be using the UDP commands. We are unable to understand how to control the GPIO lines from our PC host application.

E.g. lets say I want to toggle one of the GPIO lines on a particular event. Then in this case what would be the frame format (data field contents) for the TCP/IP or UDP command that we would be sending from host PC?

Request you to please specifically tell me the frame format (TCP/UDP) that DC-ME-01-T-S is going to receive when we send or receive a data to / from GPIO lines.
asked Apr 24, 2013 in Plug N' Play by Saurabh Singh New to the Community (0 points)
recategorized Sep 20, 2013 by tuxembb

Please log in or register to answer this question.

1 Answer

0 votes
Take a look at the Digi Connects user's guide
http://ftp1.digi.com/support/documentation/90000565_N.pdf
answered Apr 24, 2013 by Campbell Veteran of the Digi Community (916 points)
Hi,
Did you have got the solutions? I have met the similiar problems,I just want to change the GPIOs state, but if I changed the state such as the command:'set gpio range=1-5 mode=output state=asserted' it doesn't work, but when I reboot it, the GPIOs state changed. I want to know whether you met the situation or not and how you do you configuration.
I'm looking forword for your replay ,Thanks very much!
...