Home/Support/Support Forum/PortServer TS 16 serial connection to Cisco device
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

PortServer TS 16 serial connection to Cisco device

0 votes
When I make an SSH or telnet connection to the IP address/port to access the serial port of my ASA through the PortServer TS 16, I receive the login prompt. After I login successfully, I do not get anything else on the screen. If I type anything, all I get is ASCII characters.

I am not sure why this is happening and cannot find a solution.


asked May 6, 2013 in Portserver TS by deyster New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try resetting the device to factory default and also update the firmware

answered Sep 25, 2013 by sans0909 Veteran of the Digi Community (280 points)