I hope someone can help me.
I'm using two XBee Series 2 with this configuration:
1) ZNET 2.5 COORDINATOR API (1147)
2) ZNET 2.5 ROUTER/END DEVICE AT (1247)
The first XBee is connected to an Arduino board and I'm able to switch a remote pin.
All works perfectly with the default baud rate of 9600, but now I need to change the baud rate to 4800, because I have to send also some GPS serial data.
I have changed the baud rate to 4800 in both XBee with X-CTU, and I edited my arduino code setting:
XBee xbee = XBee();
Unfortunately now the the XBee can't comunicate each other, the assoc led blink and the RSSI led remain off, and the remote pin don't switch.
What I have to do to make them work with baud rate of 4800?