Home/Support/Support Forum/Antenna Problem
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Antenna Problem

0 votes
hey, guys
i have just registered this forum and i have many many things to ask but i want to start with my current problem...

i have a few XBee Pro S2B modules with wire antenna with the code XBP24BZ7WIT-004J. but in my project, it revealed that i need a closed box and the antenna should be out of the box :(

Is it possible to remove my wire antenna from my module and replace it with a UFL or RP-SMA by soldering properly??
asked May 24, 2013 in ZigBee PRO Featureset (and legacy ZNet 2.5) by harvester New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
No - because the antennas are calibrated differently. Doing this would cause the radios to perform poorly and have next to no range. In addition, it voids the warranty of the radios.

answered Jun 7, 2013 by DigiMan New to the Community (37 points)