Home/Support/Support Forum/Does DIAG connector has CTS/RTS connection?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Does DIAG connector has CTS/RTS connection?

0 votes
I am trying to interface a serial printer with RCM3209.I am using DIAG connector in the programming module to use the serial port of RCM3209.The printer datasheet clearly states that XON/OFF handshaking should be taken care of which necessitates the need of CTS/RTS pin.If the CTS/RTS pins is allotted in the DIAG connector then which I/O pin is allotted?Or is default pin BIT 6 of PORT B is allotted?Please advise.
asked Jun 17, 2013 in Rabbit Software by Embedded New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
cts/rts are not used at all, DSR (status) is connected to the DIAG
answered Jun 20, 2013 by MargaretK Veteran of the Digi Community (545 points)
0 votes
Here is a link to the schematic for the programming cable for the RCM3209 http://ftp1.digi.com/support/documentation/0900128_d.pdf.

The RTS and CTS lines from the PC end are tied together, according to the schematic.
answered Jun 25, 2013 by trooper2 Veteran of the Digi Community (589 points)