Home/Support/Support Forum/Resolving node identifier weirdness

Resolving node identifier weirdness

0 votes

[Series 1 with DigiMesh firmware and api mode]

I am using the DN command to resolve the identifier of a node. According to the docs, I should receive a response with the identifier. For some reason, this address is always 0. Does anyone know why?

After the DN command, I can read the address using DH/DL commands, so I know that the discovery itself works fine.

asked Jul 16, 2013 in DigiMesh Proprietary Mesh Networking by arnuschky New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
an address of 0 would be the coordinator
answered Sep 29, 2013 by kjensen8 Veteran of the Digi Community (653 points)