Home/Support/Support Forum/Can only get one node to associate at a time on digimesh

Can only get one node to associate at a time on digimesh

0 votes
I have a network setup with a connectport X4 with digimesh 2.4 inside and a node that is 300ft away collecting data and sending it to the X4. When I add another node that is only 150ft away from the X4 only one of the node will send data back to the X4. both have been loaded with the same .pro file from X-CTU. Just wondering if there is a that would stop both of them from being able to be in the the same network? Or what steps I can take to figure out why only one of the nodes work at a time.

But when I bring both nodes into with in a few feet of the connectport they work great.
asked Jul 29, 2013 in DigiMesh Proprietary Mesh Networking by dhipple New to the Community (3 points)

Please log in or register to answer this question.

2 Answers

0 votes
attach your config file for us to see. something must be wrong in the settings.
answered Jul 31, 2013 by kjensen8 Veteran of the Digi Community (623 points)
0 votes
How do I attach a config file. I do not see a attachment icon in the forum editor.
answered Aug 6, 2013 by dhipple New to the Community (3 points)
...