Home/Support/Support Forum/how to request an I/O rx packet??

how to request an I/O rx packet??

0 votes
By reading various books I understand how to read the API packet that is sent from the router to the coordinator. Unfortunately I'm unsure how to get this packet to be sent to the coordinator. I've read about sending AT commands (0x08) via API with no parameter value, so as to 'query' the register. But does that respond with a I/O rx packet?
I have configured two pins to be digital inputs using the ATD1 3 & ATD2 3 commands.

Im using two series 1 xbees.

Any help is greatly appreciated.

Regards, Alex
asked Jul 29, 2013 in RF Solutions and XBee by amhenderson New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Set IR to non-zero value based on your requirement. For Ex- If IR=60 then you will receive an API packet at the specified destination every 60 seconds.
Refer the following link, to decrypt the received frame, http://ftp1.digi.com/support/utilities/digi_apiframes2.htm
Select the Device Type as ZigBee and select 0x92 frame which is IO Data Sample Rx Indicator.
You can also find this information in the Zigbee product manual at digi website.
answered Sep 28, 2013 by 16ksa23 Veteran of the Digi Community (426 points)