Home/Support/Support Forum/Getting the Serial LED associated with SYN0 on WR41 Digi
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Getting the Serial LED associated with SYN0 on WR41 Digi

0 votes
Hi

I have a Digi WR41 and we are utilising a SYN0 port on the rear of the Digi(25pin in the centre of the unit).Is there any way to associate the Serial LED on the front of the unit with traffic/Online status of the SYN0 port please?

Our previous units were Sarian MR4110's which utilised a Serial port (in the same position of the SYN0 port on the new Digi) and the front LED (in this case called DTE) was lit upon it connecting.

Please help.
Ian
asked Aug 6, 2013 in Digi TransPort Cellular by huckle777 New to the Community (1 point)
retagged Aug 15, 2013 by huckle777

Please log in or register to answer this question.

2 Answers

0 votes
The serial LED of WR41 will be lit when it is connected.
answered Sep 12, 2013 by sans0909 Veteran of the Digi Community (280 points)
0 votes
That is the trouble,I am not using the serial port,I am using SYN0 as per above so even after the SYN0 port is connected I have no status LED to reflect this.

I need to associate the SYN0 port at the back with the SERIAL LED on the front of the unit,now whether this be a firmware issue or a piece of code that I am unaware of that is the question.

Thanks
answered Sep 12, 2013 by huckle777 New to the Community (1 point)
...