Home/Support/Support Forum/Communication Problem in Router API

Communication Problem in Router API

0 votes
....the thing is that i'm using to get some data from xbee modules ,
the main problem is if i send a req from coordinator to Router, i'm not getting all the routers response and some routers are missing ,
if i'll discover from XCTU then all routers are discovered hat means all are in network right.


1)i config the Routers and Coordinates in API Mode

2)Routers signal strength is good

i need all the Routers should communicate
if suppose in a n/w overall 30 routers are there ,if i send a req to Routers i can get only 20-25,and remaining 5 are not responding .i want to communicate all the routers when i send a req....please solve this problem
asked Aug 13, 2013 in IEEE 802.15.4 by Manoj kumar New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Are you using same firmware on all the Routers?
Use default settings on the Router and change only the settings which are required.
answered Sep 28, 2013 by 16ksa23 Veteran of the Digi Community (426 points)
...