Home/Support/Support Forum/ID Block on RCM6700 is missing?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

ID Block on RCM6700 is missing?

0 votes
ID Block is missing on RCM6700. Compiltion:

line 19 : WARNING SYSCONFIG.LIB : _DC_CLK_DBL_ should always be defined, but was not defined:
line 20 : WARNING SYSCONFIG.LIB : Defined _DC_CLK_DBL_ to 0 (disabled clock doubler recommendation).
line 27 : ERROR BOARDTYPES.LIB : No ID Block found on the target board.
line 28 : ERROR BOARDTYPES.LIB : Please contact Rabbit Technical Support at http://www.digi.com/support for assistance.

What to do?
asked Aug 13, 2013 in Rabbit Software by MatsSunesson New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You can re-write the IDblock using the write_idblock sample found at the following link:
answered Aug 13, 2013 by MargaretK Veteran of the Digi Community (545 points)