Home/Support/Support Forum/freeze after programming image to mx28
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

freeze after programming image to mx28

0 votes
Dear Sir,

I have got a problem after programming wi-imx28 board.
I had successfully already use this procedure with some board and not with 2 new item.

After booting on U-boot:
setenv serverip
setenv addrip
ping (successful)
update uboot tftp
update linux tftp
update rootfs tftp
setenv bootcmd dboot linux flash

Up to this step every thing looked like working as usual

And after typing 'reboot', the part freeze and impossible to reboot.

Does any body have an idea ??

Thank's a lot

Saint-Emilion (France)
asked Aug 23, 2013 in Linux by xavierdb New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
Refer Digi ESP >Help> Help Contents > Digi ESP for Embedded Linux > 16. Recovering a device 16.2. Loading a boot loader via USB
answered Aug 28, 2013 by tuxembb Veteran of the Digi Community (288 points)