Home/Support/Support Forum/XBee-PRO Communication

XBee-PRO Communication

0 votes
Dear All,

I am having two numbers of XBee-PRO RS232 adapters. How to establish a communication between these two Adapters. I am having X-CTU software.

How to start with this.

Please guide me to do this.

Thanks & Regards,
Sathish
asked Sep 10, 2013 in RF Solutions and XBee by sathish New to the Community (0 points)
What model number do you have?

Please log in or register to answer this question.

2 Answers

0 votes
it will depend slightly on what type and their firmware version. I'm going to assume you have the 2.4GHz variety with ZB firmware. In that case the following basic settings have to line up:
pan id (ID)
encryption enabled (EE)
ZS


in addition the DH/DL values either need to be set to broadcast or the address of the other (SH/SL).

Using sleep can complicate matters. Sleep is disabled if SM=0

Send your configuration files and we can comment further.

Keith
answered Sep 14, 2013 by kjensen8 Veteran of the Digi Community (623 points)
0 votes
I have the same problem did,t you find the trouble ?
answered Mar 31, 2014 by Jocelyn Fiset New to the Community (2 points)
...