Why must I Cycle Power on anywhereUSB14 for it to be discovered after a server power cycle?

Question

Scenario:
1. My server and AnywhereUSB 14 are both powered down.
2. The sever and AnywhereUSB are powered up at same time.
3. The Server(a vmware ESX host) takes > 10 minutes to fully startup and the virtual machines up and running.
4. The virtual machines do not reconize the AnywhereUSB
5. I have to cycle the power on the AnywhereUSB, which means pulling both power plugs since the unit doesn't have a power switch, to get the virtual machines to recognize(discover) the AnywhereUSB and everything works great.

Question:
Is the AnywhereUSB timing out somehow because the server takes so long?
The AnywhereUSB has a fixed IP.
TAny advice would be greatly appreciated.

Answer 1

If you receive the error message -" no concentrators found"
refer to the KBase

http://www.digi.com/support/kbase/kbaseresultdetl?id=1026

also refer to the below KBase articles as well

http://www.digi.com/support/kbase/kbaseresultdetl?id=1031

http://www.digi.com/support/kbase/kbaseresultdetl?id=1061