Home/Support/Support Forum/testing Xbee modules
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

testing Xbee modules

0 votes

I am testing two zigbee modules to learn how work zigbee protocol.

I've started with a simple example. I've got connected a coordinator and a router in AT mode and works fine. I can send text from one another...

I've got both modules in the same room but when I've got one module and leave the room the connection is lost.

I had read in document: http://ftp1.digi.com/support/documentation/90000976_G.pdf

Indoor/Urban Range up to 133 ft. (40 m)

The code of my xbee modules is: XB24-Z7PIT-004 revC

Thank you so much, best regards.
asked Jan 10, 2014 in ZNet 2.5 by oscargomezf New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
The problem is solved. I think the problem could be I bad configuration.

I upload the firmware again, without force the module to maintain its current configuration and configuration the parameters "ID": PAN ID, "DH": Destination Address High and "DL": Destination Address Low again...

Now works fine.
answered Jan 10, 2014 by oscargomezf New to the Community (2 points)