Home/Support/Support Forum/ZIGBEE high power Coordinator won't talk to ZIGBEE Routers

ZIGBEE high power Coordinator won't talk to ZIGBEE Routers

0 votes
I have a working network with a mix of high and low powered ZIGBEE units. I can get the network to work with a low power unit as Coordinator but can't get it to work with a high power unit as the Coordinator. I have tried several high power units with no success. I can successfully use both types as Routers. The PAN addresses are all the same, DH on the Coordinator is 0 and DL is FFFF. The Routers are set to DH = DL = 0. Is there a parameter I'm missing?

Also, the update rate is about 5 times per minute. I am sending time data and I need a rate of 1 second or less. Is there a setting that controls this?

Thanks for any suggestions,
asked Jan 15, 2014 in RF Solutions and XBee by dnorbury New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
What do you mean by you can't get them working? Are they not associating or attempting to associate with the Coordinator?
answered May 12, 2014 by mvut Veteran of the Digi Community (14,881 points)