Home/Support/Support Forum/How can i use the API mode to configure remote xbee devices?

How can i use the API mode to configure remote xbee devices?

0 votes
I don't know to use API mode in XBEE S2 ZB. I need integrate this device with PSoC, and i think that this device is useful to configure others remote device, exchange information, and measurement sensors using API mode. But i don't know how can i do this, without to use x-ctu. Is possible configure remote devices in this mode?
asked Feb 4, 2014 in RF Solutions and XBee by dmatos New to the Community (5 points)

Please log in or register to answer this question.

2 Answers

0 votes
I'm new to XBee myself, but I've been using this article as a guide.

http://www.digi.com/support/kbase/kbaseresultdetl?id=3221
answered Feb 16, 2014 by niftynei New to the Community (5 points)
0 votes
If you don't want to configure the modules using X-CTU then you need to use digi Gateway and update the API firmware on the modules.
answered Feb 17, 2014 by 16ksa23 Veteran of the Digi Community (426 points)
...