Home/Support/Support Forum/Node Discovery. What is the deafult content in the serial response?

Node Discovery. What is the deafult content in the serial response?

0 votes
Hello Friends.

First: I have looked in this forum before asking and couldn't find any topic about my question.

In the AT mode, what is the default format for the AT ND command response?
Here http://ftp1.digi.com/support/documentation/90000976_B.pdf on page 77 it shows:

NI<CR> (Variable length)
DEVICE_TYPE<CR> (1 Byte: 0=Coord, 1=Router, 2=End Device)
STATUS<CR> (1 Byte: Reserved)
PROFILE_ID<CR> (2 Bytes)

But I cant identify where is the RSSI/Dbm information.

I am connecting the XBEE with my FPGA and so I need to send through a UART to the XBEE this command AT ND. I need just to know the format for this AT ND command.

thank you very much!
asked Feb 21, 2014 in IEEE 802.15.4 by maurolarrat New to the Community (0 points)
A good suggestion for an active forum would also be  appreciated.

Please log in or register to answer this question.

2 Answers

0 votes
That is because the RSSI value is not provided in a ND response. Try having the remote device send data and then Query your local DB command.
answered May 7, 2014 by mvut Veteran of the Digi Community (15,412 points)
0 votes
answered Mar 30, 2015 by wz2b Community Contributor (50 points)