Home/Support/Support Forum/BL2010 Rabbit Board developed red (bad) light during cloning now nothing can be loaded
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

BL2010 Rabbit Board developed red (bad) light during cloning now nothing can be loaded

0 votes
Trying to clone the board. Used the software to test the target board but now after several attempts to load program there is a red light on the target board that says "bad".
The software recognizes the board but cannot load anything on to it.
asked Mar 5, 2014 in Rabbit by sbvancel New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Are you able to run a sample program in Dynamic C? What software are you using to test the board?
answered Mar 5, 2014 by MargaretK Veteran of the Digi Community (545 points)
It's actually a BL2020 but none of the provided test programs seem to work.
Initially the one that cycles through the lights worked and then at some point stopped loading.
commented Mar 6, 2014 by sbvancel New to the Community (0 points)
OK, looks like the programs we were trying to load were corrupted. Reinstalled them and it seems to function properly now.
commented Mar 6, 2014 by sbvancel New to the Community (0 points)
...