Home/Support/Support Forum/xbee Xb24-z7wit-004 XCTU detection problem.

xbee Xb24-z7wit-004 XCTU detection problem.

0 votes
Hi friend i need help regarding communicating xbee Xb24-z7wit-004. i am not able to communicate with it via x-ctu.. i have tried to download the new firmware but no success. i want to use xbee in direct mode. so which version should i download into xbee. I have tried to use terminal window to reset xbee and enter into bootloader but no success. I am using serial board with xbee to comm with pc. The Rx led on the board blinks but does not communiate. Plz help me to solve this.
asked Mar 14, 2014 in IEEE 802.15.4 by asrarulhaq New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
My knee jerk reaction is mismatched baud rates. A "Restore" using X-CTU should reset the radios back to 9600 baud. If that does not help try the methods found here:

http://www.digi.com/support/kbase/kbaseresultdetl?id=3402
answered Mar 24, 2014 by MikeN Community Contributor (87 points)
...