Home/Support/Support Forum/how to configure XBEE to avoid the data collision
New and improved user forum site coming soon

how to configure XBEE to avoid the data collision

0 votes
Hello professors,

I am using XBEE to achieve the data transformation. I plan to use two routers and one coordinator. Each router will send the relevant data to the coordinator in a required time. Previously, I configured the XBEE both coordinator and router in X-CTU software.

My question is how can I configure XBEE to make sure that the XBEE has been set to the order of the avoidance of data collision? Is there any tutorial I can read or do you have some suggestion? I'm really appreciate your advice, Thanks again.

Best regards.
asked Mar 17, 2014 in RF Solutions and XBee by saina110 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

+1 vote
The 802.15.4 protocol already has built-in mechanisms to avoid the problems caused by collision. If you are using multiple networks then make sure each separate network talks on a different channel. (CH)
answered Mar 24, 2014 by MikeN Community Contributor (87 points)
wireless sensor network