Home/Support/Support Forum/Communication problem with xbee pro s3b
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Communication problem with xbee pro s3b

0 votes

I have a communication problem with my xbee pro S3B

I have verified my FTDI driver setting on my computer , everythings are ok. I can see with my oscilloscope the data on pin DATA IN on the XBee but no data out a the pin DATA OUT.....

The XCTU software does not recognise the xbee module

please hlp me i am a beginner ....
asked Mar 24, 2014 in Other/Legacy by Jocelyn Fiset New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
- Make sure COM port and Baud rate settings are correct
- Make sure the interface board is working fine
- Use other XBee module on the same interface board and check whether the module is working
- Use different interface board and check whether the module is working
- If nothing helps, reflash the module with correct Function set and Version
answered Apr 9, 2014 by 16ksa23 Veteran of the Digi Community (426 points)
Contact a Digi expert and get started today! Contact Us