Home/Support/Support Forum/Using IF_ETH1
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Using IF_ETH1

0 votes
Can anyone tell me if IF_ETH1 works or not on the RCM6700, and if so, how does one go about using it?

Everything in the documentation suggests that it should work just fine, and IFCONFIG() does not return an error code. But IF_ETH0 works just fine, while IF_ETH1 does not appear to.

Anyone have any ides/suggestions?
asked May 5, 2014 in Rabbit by dynamphorous New to the Community (4 points)
recategorized May 4, 2014 by dynamphorous

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
Hello, It seems like, if you your board has two ethernet interfaces then only you can use the above two macros, otherwise you can use only the IF_ETH0
For more info on this , check TCP/IP user's manual Volume 1 at Digi's website.
answered May 5, 2014 by cpigilam Veteran of the Digi Community (655 points)
selected May 5, 2014 by dynamphorous
Thank you for your reply. I figured this out within 2 minutes of asking the question (I was trying to create a virtual ethernet connection, and figured out how to do that) I just was unable to delete my question. But thank you for your prompt reply!
...