Home/Support/Support Forum/Range test with XBee Pro s1 problems

Range test with XBee Pro s1 problems

0 votes
I have two XBee's set up on two different computers I ran the test query and they both came up fine. Both of them are set to the same chanel same baud rate and same Pan ID. When I run the range test on both PC's at the same time I get a "timeout waiting for data" error. How do I do the range test? I have tried so many things.
asked May 15, 2014 in RF Solutions and XBee by jhangir New to the Community (1 point)
Apparently the API setting in the modem configuration tab must be DISABLED for the range test to properly work. I used two computers and two Xbee modules to get the test to work properly.

Please log in or register to answer this question.

1 Answer

–1 vote
Try following the steps described in the XCTU users Guide located at http://ftp1.digi.com/support/documentation/90001003_A.pdf
answered May 20, 2014 by mvut Veteran of the Digi Community (12,790 points)
...