Home/Support/Support Forum/Hello, I have 2 modules Xstick2 with broken bootloader. How I can fix it?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Hello, I have 2 modules Xstick2 with broken bootloader. How I can fix it?

0 votes
asked Jun 24, 2014 in USB Serial by StaTronic New to the Community (3 points)

Please log in or register to answer this question.

5 Answers

0 votes
The only thing you can try is to issue new firmware over the air or via the UART. If that does not work, then you need to either try to get an RMA or replace them.
answered Jun 24, 2014 by mvut Veteran of the Digi Community (14,807 points)
0 votes
OS Windows see module as USB Serial Port, and I think what port FTDI on the PCB work correctly and problem in microcontroller (bootloader is broken).
answered Jun 25, 2014 by StaTronic New to the Community (3 points)
0 votes
What is RMA? Is exist any wire interface on pcb (as jtag) for help in this problem? (for download bootloader in microcontroller and then connected with XCTU)
answered Jun 25, 2014 by StaTronic New to the Community (3 points)
0 votes
How do you determine that the bootloader is broken? If you cannot access because the module is sleeping you can try to enter bootloader as described for regular XBees.
To reset your XStick without unplugging it, follow these instructions
P/S: An RMA is a Return Mechandise Authorization.
answered Jun 27, 2014 by spastor Veteran of the Digi Community (403 points)
XCTU don't detect them in all cases except reset.
0 votes
XCTU don't detect them in all cases except reset.
But, in recovery mode XCTU "was say" what rewrite firmware, but, Xstick don't work after that. Led blinking 2 times per second.
answered Jun 29, 2014 by StaTronic New to the Community (3 points)
...