Set programmable Version as a coordinator

Question

Hi,

I basicly want to have my two programmable XBees to communicate without the XStick. So I changed one XBee via XCTU to a Coordinator (set Coordinator Enable 1 and Destination Address Low FFFF) and flashed the "Transmit basic frames Example" into the other(everything worked fine here with the XStick). So my question is, can i configurate my programmable Xbee so that it behaves like the XStick?
Should i change something with the PAN-Adress or something?

Greetings

Answer 1

What is the full part number of the XBee modules you are working with? What firmware versions are installed?

Answer 2

The Product number should be XB24CZ7PISB003

therefore its the programmable SMT-version.

afterall my XBe is broken(i think) and i need to recover. in http://www.digi.com/support/kbase/kbaseresultdetl?id=3402 i found "If you have a programmable XBee, contact Digi Support for troubleshooting. "

in new XCTU-version i started recovery and the messages:

Code:

- Looking for active bootloader... [ERROR]
        There is not an active bootloader in the module.
- Resetting and entering bootloader... [ERROR]
        There is not an active bootloader in the module.

came.
So i tried to reflash bootloader project with the freescale-project but nothing changed. Hot can i flash a working bootloader?
EDIT:
I tried to get into terminal.
getting this as it should be! so there should be a working bootloader.

Code:

.B-Bypass
.F-Update App
.T-Timeout
.V-BL Ver.
.A-App Ver.
.R-Reset
.vvBL032-2C0-D37_064

can i update the firmware with this?