Home/Support/Support Forum/How do I determine the bus/slot used with the pciinfo directive in dgap.conf?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How do I determine the bus/slot used with the pciinfo directive in dgap.conf?

0 votes
In the test dgap.conf file below, how can I confirm the bus, slot numbers are correct for each pciinfo line? The Redhat EL4 dmesg shows the follow IRQ's for the three C/X cards:

dgap: dgap-1.3-6, Digi International Part Number 40002347_C
dgap: For the tools package or updated drivers please visit http://www.digi.com
ACPI: PCI Interrupt 0000:0c:01.0[A] -> GSI 24 (level, low) -> IRQ 201 24
dgap: board 0: AccelePort CX (rev 3), irq 201
ACPI: PCI Interrupt 0000:0c:02.0[A] -> GSI 26 (level, low) -> IRQ 209 26
dgap: board 1: AccelePort CX (rev 3), irq 209
ACPI: PCI Interrupt 0000:14:01.0[A] -> GSI 19 (level, low) -> IRQ 193 19
dgap: board 2: AccelePort CX (rev 3), irq 193

# cat dgap.conf
config_begin
board Digi_AccelePort_C/X_PCI
io 0x000
mem 0x000000
pciinfo 20 1
line 0
speed 14
conc ccon
speed 14
nports 16
id aaa
start 1
line 1
speed 14
altpin 1
useintr 0
board Digi_AccelePort_C/X_PCI
io 0x000
mem 0x000000
pciinfo 12 1
line 0
speed 14
line 1
speed 14
altpin 1
useintr 0
board Digi_AccelePort_C/X_PCI
io 0x000
mem 0x000000
pciinfo 12 2
line 0
speed 14
conc ccon
speed 14
nports 16
id caa
start 1
line 1
speed 14
altpin 1
useintr 0
config_end
asked Jul 22, 2014 in Serial Cards by bobmcg99 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
This slot: 0000:0c:01.0, maps to the dgap.conf adatper showing: pciinfo 12 1 (no I.D. assigned).

This slot: 0000:0c:02.0, maps to the dgap.conf adapter with: pciinfo 12 2 (I.D.: caa)

This slot: 0000:14:01.0, maps to dgap.conf adapter with: pciinfo 20 1 (I.D. aaa).
answered Sep 2, 2014 by userid0 Veteran of the Digi Community (2,158 points)
...