Home/Support/Support Forum/Problems on running the sample programs of slaveport in RCM4000.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Problems on running the sample programs of slaveport in RCM4000.

0 votes
Programs being run on both the slave and master are:
Slave side-SLAVE_DEMO
Master side-MASTER_DEMO
While running the sample programs of slave port in RCM4000, I get the following output on the master:
"Got Read Error= -1"
"Wrfree= -1"
Why is the data not being read from the slave?
asked Aug 1, 2014 in Rabbit Software by AISWARYA RAJ New to the Community (1 point)
edited Aug 1, 2014 by AISWARYA RAJ

Please log in or register to answer this question.

1 Answer

0 votes
These samples were written for some Rabbit 3000 products such as the RCM3200 which had circuitry on the protoboard which allowed two RCM3200s to be plugged in, one as master and one as slave.

Take a look at the schematic for that protoboard to get an idea of what kind of connections you would need between the two boards.
answered Sep 4, 2014 by trooper2 Veteran of the Digi Community (589 points)
...