Home/Support/Support Forum/Latency between tx and rx modes

Latency between tx and rx modes

0 votes
Currently I'm using two XT09-PKI-RA modems and every once in a while a packet is being dropped.
We're using it in the default transparent mode. I'd like to know the latency in switching between tx and rx modes. For example, if I wanted to send/receive single characters between the two modems (both set to 115.2K for data and rf rates) - would I need to add a delay between receiving and transmitting - if so, how much delay?
Is there a more detailed description of the transparent mode?
asked Aug 15, 2014 in XTend by ec_1993 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
I think some of the information can be found at http://www.digi.com/support/kbase/kbaseresultdetl?id=2044.

If it is not listed there and in the manual, then it has not been released.
answered Aug 18, 2014 by mvut Veteran of the Digi Community (13,087 points)
selected Aug 18, 2014 by ec_1993
...